#Bike chain too long full#

#Bike chain too long full#

Stretching is a sign of wear, and once your chain exceeds the recommended maximum on a chain stretch gauge, it needs a full replacement. Chains will also 'stretch' over time, but do not shorten the chain to address this issue. Shift the gears manually to move the chain to the smallest cogs. If your replacement bike chain is too long for your bike, youll need to adjust it first for safe riding.When the chain is the right length вЂ“ with some movement to the derailleur arm вЂ“ you can split the chain using the chain tool.Make the determination before you continue your effort. There are two possibilities for the next step вЂ“ for a Shimano chain, you need to have an inner and outer plate at the end of the chain, while a SRAM or KMC chain needs two inner plates at each end of the chain.Having a broken spoke handy is the perfect way to keep the chain taut and in position. Next, shift to the smallest chainring and sprocket. The chain should be long enough to make this shift with two slight bends at each pulley of the rear derailleur. Shift the bike into the largest chainring and rear cog. Measure which to split by holding them in place where they meet. Before removing the old chain, verify that it is the correct length. Once you have the chain in place, pull the two ends towards each other.Take note that you should never ride in this gear. In order to do that correctly, youвЂ™ll have to adjust the chain so that it is fitted to the two largest rings вЂ“ the one in the front and the one in the rear. In order to make sure the chain operates no matter what gear you use without damaging the bicycle, youвЂ™ll need to size it properly. Now, itвЂ™s time to actually fit the chain and assure itвЂ™s going to function properly. Do this gently to avoid damage to the chain or bike and to assure the chain doesnвЂ™t fall off. At this point, you can release the derailleur.Finally, send it through the lower tab of the derailleur cage arm.Continue threading by taking the chain through the lower jockey wheel Is my bike chain too long I have followed GCN's guide to measuring a chain however when in the lowest cog at the back the rear derailleur seems too close to the rear cassette.From there, thread it behind the tab in the derailleur cage arm.Next, thread the chain over the top of the upper jockey wheel.You want to have a few inches dangling under, so you can then place the other end of the chain in the seatstay, then lay it across the cassette. Start by threading the end of the chain through the front derailleur.Now, itвЂ™s time to set to work on the chain itself. Next, release any clutch mechanism you may have on the rear derailleur.Repeat this for the front, setting it to the largest chain ring.Using the gear shifts, set the rear derailleur to the biggest cog.Before you can put on the new bike chain, youвЂ™ll need to make some adjustments on your bicycle.